3D model of the motor Area

Model3D

This is a quick presentation of the 3D model of the rear motor area. You can see the adaptor plate with the frame that will replace the original motor structure.
The part on the rear is an origin part. It has two mounting points on top to hold the motor to the structure of the 911.the last ounting point is on front of the tranismission.
The controller will be on top as shown on the picture. I need to make sure the cooling hoses don't go too high so that the cooling reservoir is the highest point.
You can see 5 batteries packs on the left. The battery racks are not done in 3D because it would take to much time. The same 5 packs will be on the right side and 4 packs will be on front of the car.